Our Work
Photographs from lock jobs, grouped by the kind of work: a door with its old hardware taken out, levers and a deadbolt cylinder, and the wear that pulls a commercial door out of line.
These photographs come from lock jobs. They show the doors and the hardware as the work found them or left them, and nothing else: no street, no customer, no date.
Each kind of work leaves its own marks on a door. A lock change shows in the holes it opens or fills; commercial work shows in heavier hardware, and in how the door hangs and closes.
Rekeying and Lock Changes
Of the two ways to change the keys to a door, only one shows in a photograph. Rekeying leaves the hardware where it is and changes the pins inside the cylinder. Replacing a lock takes everything off the door, and what is left in the wood or steel shows what the next lock has to fit.
With its hardware out, the steel door shows two bores through its face, and the next lock has to suit them. Most residential locks take a 2-1/8 inch bore, set back 2-3/8 or 2-3/4 inches from the edge of the door, and most doors are 1-3/8 inches thick inside a house and 1-3/4 inches on the outside. Hardware that matches those numbers goes straight into the old holes.
Hardware that does not match takes more: a bore recut to a larger size, a cover plate over holes the new lock leaves open, or on a wood door, the old holes plugged and drilled again. Interior doors usually carry a lever or a knob with no key at all, a passage or privacy set, and changing one comes down to the bore, the backset and the finish.
Business Locks
Shop and office doors open and close all day, and their hardware is heavier for it: levers in place of knobs, closers that pull the door shut, cylinders that can be rekeyed or swapped across a whole building, and on exit doors, hardware that opens from inside without a key.
The deadbolt cylinder on the maple door has the figure-eight face of an interchangeable core. A control key draws the core out of its housing and a core pinned to different keys slides in, so the lock changes keys without coming off the door. Buildings on a master key system often use them for that reason.
The rest of a commercial door wears as hard as its lock. A threshold takes every footstep and every hand truck rolled over it: grit packs its ribs, winter salt rusts the hinge screws nearest the floor, and the door starts to drag. A closer adjusted while the door still swung easily then stops short of latching, and an unlatched door is an unlocked one. A shop door in that state is worth a call to (612) 662-1116.
Matching Finishes
Lock hardware comes in standard finishes, each with a trade code, and three common ones turn up in these jobs: satin chrome, US26D, on the lever of the push-plate door; satin nickel, US15, the finish stores call brushed nickel, on the lever of the wood door; and brushed steel on the plate under the deadbolt cylinder.
When one piece on a door changes, say a new deadbolt over an old lever, the finish is part of the choice. Matched finishes read as one set, while a chrome deadbolt over a brass knob reads as a repair. Commercial doors lean toward satin chrome and stainless steel, which hide wear better than polished brass.
For a lock change, the finish of the hardware staying on the door is worth naming in a request through Schedule an Estimate.